Adept technology Adept XUSR Bedienungsanleitung PDF herunterladen (Seite 10)

1.6 Configuration

1.6 Configuration

The user-supplied PLC and Cobra robot are connected either through a shared network or via

a user-supplied Ethernet cable.

When the Cobra ePLC robot is powered on and waiting for a PLC connection, the robot status

panel will display its IP address, two digits at a time.

The format will be:

IP xxx-xxx-xxx-xxx OK

NOTE:If you can use the robot’s default IP address, then you can skip the Adept

ACE software installation completely.

Installing Adept ACE Software

Adept ACE is used to change the IP address of the robot and for troubleshooting. You install

the Adept ACE software onto your PC from the Adept web site download center.

NOTE:You will have to restart the PC after installing Adept ACE software.

Setting the Robot IP Address

Configure the IP address of the Adept Cobra ePLC robot using Adept ACE software.

Connect the PC and the robot, either through a shared network or with an Ethernet

cable between them.

Start the Adept ACE software.

Click the Detect and Configure button, circled in the following figure.

Figure 1-8. Detect and Configure Button

Adept Cobra ePLC600/800 Quick Setup Guide, Rev C

Page 10 of 16

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Adept technology Adept XUSR Bedienungsanleitung Seite 10